Brackets and tabs

[upnover]

As many know. We are now making bead locks. We are also cutting tabs and brackets out of the areas in the metal that would otherwise go unused. We have a good selection, but open for new ideas. IF you can give me some dimensions and so forth and what application it's for. We may be able to cut it out.
Thanks
Chip

 

[Spence]

i know this is most likely a little larger scale than what you are talking about, and i dont have many good dimensions to give you, but one thing i would love to see is a more affordable tj/xj front bracket kit, with lower coil mounts, and upper and lower control arm mounts

most out there seem way overpriced, or maybe someone could direct me to somethgn cheaper ive never seen?